Accessory Table Usage; Table Clamping Bracket; To Install T-Nuts For Guide Fence Brackets - Craftsman 21829 - Professional 10 in. Portable Table Saw Operator's Manual

ACCESSORY TABLE USAGE
Th|s accessory table has been spec'dtcalty designedfor
use with listed Craftsmen Routars.The hole pattern on the
accessory table has notbeen drfflad to accommodate all
reuters. Reuters must not exceed 3 HP (maximum devel-
oped) or weigh more than 12-1/2 Ibs. Reutersmust have
took-on switch feature.
TABLE CLAMP|NG BRACKET
See Figure 51.
The lever on the accessory table wilt.tighten the table se-
curelyto the front rail. The weight of the muter may cause
the accessory table to loosen or have movement st the
rear of the table. To avoid this, install the table clamping
bracket.
NOTE: Positionthe table clampingbracket so that the
accessory table is centeredover it.
II Slide one of the T-nuts into the front channel of the
rear rail and under the aooeseorytable.
• The table clamping bracket fits in the bottom slot of
the rear railand the slotted top of the bracket wraps
around the raised portion on the undersideof the
accessory table.
• Secure wlth a 5/16 in. washer and a 5/16-18 x 3/4 in.
knob bolt.
• Tighten the knob bolt securely.
TABLE CLAMPING BRACKET
SHOWN COMPLETELY _
ASSEMBLED __,._
ACCESSORY L L_L)_
T. , E
TABLE CLAMPING
BRACKET
T-NUT
_/'16 in.WASHER
KNOBBOLT
END
CAP
Fig. 51
T-NUT BETWEEN
ADJUSTMENT
SCREWS
REAR
ADJUSTMENT
SCREW
RIP FENCE S HOWNLOCKED A GAINST SAWBLADE
Fig, 52
TO INSTALL T-NU'£_ FOR GUIDE FENCE
BRACKETS
See Figures52.53.
• Place rip fence against blade and lock in place,
• Usingthe appropriate hex key supplied with your table
saw, remove the rear adjustment screw and washer on
top of the rip fence.
• Slide one of the T-nutsintothe top channel of ripfence
and place between the two adjustment screws.
NOTE: T-nutsinstallfrom the rear of the rip fence.
• Replacethe washer and the rear adjustmentscrew and
tighten securely.
• Checkthe rip fsncs for squarsnesswith ths saw blade,
• Unlock the rip fence, slide it away from the saw blade,
and lock it in place,
Slidethe four remainingT-nuts into the top channelof
ripfence.
NOTE: Five T-nuts shouldbe in the top channelof
the rip fencewith only one of them between the
adjustmentscrews on the rip fence.
37