To Lock Sliding Miter Table; To Check Sliding Miter Table Assembly; To Install Accessory Table - Craftsman 21829 - Professional 10 in. Portable Table Saw Operator's Manual

I!_STIIIG CI_II, N[P
MITERFENCE KNOB ATI'ACHMEN'T
MITER HOLDER BOLT
FENCE
HOLE"A"
\ ,
LOCATOR P iN
INDICATOR
TABLE SLOT
HOLE=B"
QUICK STOP HOLE "C" Fig. 20
TO LOCK SLIDING MITER TABLE
See Flours21.
The miter table elides allowing the operatorto elide the
workplsce across the saw, A miter slide lock is mounted
on the front of the miter table to lock it in place. The miter
slide lock is placed in a slot on the base to align the miter
tabla with the h'ont edge of the saw table. The sliding
miter table shouldbe locked for any cut in which the
operator prefersa fixed table.
• To lock the miter table with the base projectingto the
front, place miter slide lock in the back slot on the
base.
• To lock the miter table with the base projectingto the
back, place miter slide lock in the front slot on the
base.
MITER
SLIDE LOCK
TO CHECK SL|D|NG M_'ER TABLE ASSEMB!3/'
The square relationship between the blade and the miter
fence as it travels the entire distancefrom the frontto the
rear of the miter table base duringa cut is very important
for m_ng preciseand accurate cuts.The slidingmiter
table assembly has been preset at the factory. However,
misallgnment during shippingor requirementsfor very
precise and accurate cuts may requirerce[ignment.
To avoid unnecessarysetups arid ad.iuatments, w e
suggest that you check these setups carefullywith a fram-
ing square and make practicecuts in scrap wood before
making finishcuts in good workpisces.
NOTE: Followthe general rule of measuring twice and
cutting once.
Do not loosen any screws. Once screws have been loos-
ened, settings must be reset.
Two basic checks should be made before using the miter
table"(1) the miter base must be parallelto the blade as
the table slides fTomthe front to back, and (2) the miter
fence must be squareto the blade when set at exactly
zero (0") on the rafter table scats.
NOT_ The miter table has adjus_ant screws for squar-
ing miter fence tc blade and maintaining0 ° scale settings
when miter base adjustments are rsc, u ired.These checks
and adjus't_entsare exp_ined in step-by-step procedures
in the Opera#on sectionend depend on each other.
TO INSTALL ACCESSORY TABLE
See Figure22.
• Fit the tabs on the back of the accessory table into the
rear rail.
• Posi_onthe slot on the undersideof the accesaory
table ontothe frontrail and tighten the lever securely.
NOTE: To use the optional routeraccessories included
with this product, refer to the Operationsectionfor usage.
ACDESSORY
TABLE
TO
LOCK REAR RNL
SLOT8FOR LOCKING
MITER TABLE
Fig. 21
\
TO
UNLOCK LEVER
FITUP OFT_B, LE
IKTOREAR RAIL
Fig. 22
21