Set The Sensitivity; Set The Dip Switches - Honeywell 5800PIR-RES Installation Instructions Manual

IF NECESSARY, CONFIGURE DETECTION MASKING
1.
Spread the Cover and gently press on the
Lens to remove the Lens Holder.
5.
Replace the Lens by aligning the 4 cutouts
on the lens to the 4 projections inside the
cover. Snap in place with the Lens Holder.
Cover
Lens

SET THE SENSITIVITY

1.
Set the Sensitivity Select Switch to the desired
sensitivity.
DIP
Switches
Low Sensitivity - Best to prevent false detections.
High sensitivity - Best detection catches (increased
false detections). Use for applications where you are
tagging video, or need high security awareness.
2.
Separate the Lens from the Cover.
Lens
Holder
3.
Identify the segments on the Lens to be masked.
6.
Ensure the Lens Holder is held by the left and
right cover prongs and the two tabs are engaged.

SET THE DIP SWITCHES

1.
Sensitivity
Select Switch
(Low, Med, High)
Default Setting
Cover
Lens
Area Masking
Plate
Lens
Holder
At the DIP switches, set switch 2
for the desired Battery Saving
Timer period.
Note: The alarm output
activations are limited by the timer
selection (5 or 120 seconds). Even
if there are continuous alarm
events, the alarm output operates
only once in the selected timer
period. This period can be set for 5
or 120 seconds.
120s – Default Setting
5s – Used when frequent alarm
transmission is required. Battery
life will be shortened when using
this setting.
– 4 –
4.
Then apply the adhesive Masking
Strip(s), as necessary, inside the
lens to mask the desired
segments.
5
4
3
2
1
1 2 3 4 5
Cover
2.
Set switch 3 for the desired Pulse Count
(selectable for 2 or 4).
Pulse Count of 2 = detection can be
made with as little as two steps.
Pulse Count of 4 = detection can be
made with as little as four steps.
3.
Set switch 1 to enable the Walk Test,
then perform the walk test on the next
page.
OFF
120s
4
Default Setting
7
6
8
9
10
11
12
13
6 7 8 9 10 11 12 13
ON 1. Walk Test
5s 2. Battery Saving Timer
2 3. Pulse Count