Table of Contents
Advertisement
To power off the system from Suspend mode
1.
Press the Suspend/Resume button to make the system active.
Press the Power button to turn off the system.
2.
Setting Switches
A six-position dip switch is located underneath the keyboard. (Dip switch instructions and
location for accessing the switches follows this section.) The following lists identifies each
switch setting and its function.
T
Switch 1, BIOS Flash Protection Switch — The default setting is "ON." Change
the setting to "OFF" when you update your system's basic input/output system
(or BIOS) flash memory. See "Updating the System BIOS," to complete this
procedure.
T
Switch 2, Password Override Switch — The default setting is "OFF." For exam-
ple, if you forget your password and cannot access the data on your NEC Versa,
change the setting to "ON" and your current password dissolves.
Figure 2-12 Dip Switch Location
NOTE
Switches 3, 4, and 6 are reserved for NEC
factory use only. Switch 5 is not used.
Setup and Operation
2-15
Advertisement
Chapters
Table of Contents
