Lcd Status Bar, Versaglide Assembly, Metal Keyboard Supports - NEC VERSA 6060 Service Manual

4-14 Field Service Guidelines

LCD Status Bar, VersaGlide Assembly, Metal Keyboard Supports

Remove the LCD status bar, VersaGlide, and/or metal keyboard support as follows.
1. Remove the LCD, top cover, keyboard, power button and rear IR assembly as
previously described.
Remove the LCD status bar as follows.
2.
T
Locate the ribbon cable that attaches to the CPU board via connector P6.
T
Use the tip of a screwdriver and carefully open the connector tabs.
T
Lift up the LCD status bar.
Figure 4-11 LCD Status Bar, VersaGlide Assembly, Metal Keyboard Supports
Remove the VersaGlide assembly as follows.
3.
T
Locate the cable on the VersaGlide assembly.
T
Disconnect the cable from connector P7 on the CPU board.
T
Lift the VersaGlide out of the base unit.
Remove the system audio board as follows:
4.
T
Locate the system audio board. The audio board rests on the top of the metal
keyboard supports, right above the IR assembly.
T
Remove the screw and metal bracket. Lift the audio board out of connector
P10 on the CPU board.