Door Reinstallation - Maytag MFC2061HE Use And Care Manual

Installation
4. Remove Phillips screw
from each of the drawer
slides (select models).
5. Lift top of drawer front to
unhook the drawer from
the slides. Lift door front
out to remove.
To Install:
1. Pull both rails out to
full extension.
2. While supporting door
front, hook supports
into slots located on
inside of each slide.
Note
: All four drawer bracket supports must be in
the proper slots for the drawer to function properly.
3. Lower door front into final position.
4. Replace and tighten Phillips screws that were
removed from the drawer slides (select models).
5
5. Place the basket cradles back onto the drawer
slides. Align basket cradle snaps with the slots on
the drawer brackets and press each cradle toward
the bracket until it clicks.
Basket cradle
snap attachments
6. Tilt the lower basket front down and set it down
into the basket cradles.

Door Reinstallation

Materials Needed:
• Phillips screwdriver
• ⁄ " hex head driver
5
1 6
1. Install hinge assemblies:
• Install center hinge with Phillips
screws.
2. Place hinge side of refrigerator
door on center hinge pin.
• Install top hinge with
head screws.
3. While holding refrigerator door
upright, tighten down top hinge
with " hex head driver.
5
⁄
16
4. Reconnect two-pin connector.
5. Replace top hinge covers.
" hex
5
⁄
16