Door And Drawer Removal - Maytag MFC2061HE Use And Care Manual

Installation
7. Replace the toe grille.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.

Door and Drawer Removal

Some installations require door/drawer removal to
transport the refrigerator to its final location.
Materials Needed:
• Phillips screwdriver
• 5 ⁄ " hex head driver
1 6
• 3 ⁄ " hex head driver
8
WARNING
To avoid electrical shock which can cause
severe personal injury or death, observe the
following:
• Disconnect power to refrigerator before removing
doors or drawer. Connect power only after
replacing doors or drawer.
CAUTION
To avoid damage to walls and flooring, protect vinyl
or other flooring with cardboard, rugs or other
protective material.
1. Unplug power cord from power source.
2. Remove toe grille (see page 3).
3. Remove top hinge cover from refrigerator
door by removing Phillips screw and
retain screw and cover for later use.
4. Unscrew 5 " hex head screws from top
⁄
16
hinge to remove hinge and retain all
screws for later use.
5. Lift right side refrigerator door from
center hinge pin. Remove door
closure from center hinge pin on
the right side and retain for later
use.
6. Disconnect wire harness on top of
left side refrigerator door top
hinge.
• Release two-pin connector by
pressing junction point with a
flat blade screwdriver or
fingernail.
• Green ground wire remains attached to the
hinge.
7. Unscrew
from top hinge to remove hinge
and retain for later use.
• Lift left side refrigerator door,
along with top hinge, from
center hinge pin.
• Remove center hinge pin with a
driver and retain hinge pin for later use.
8. Remove Phillips screws to
remove right and left hinges and
retain all screws for later use.
9. Remove both stabilizing
brackets with
and retain screws for later use.
Pullout Freezer Drawer
To prevent accidental child entrapment or
suffocation risk, do not remove the divider in the
top freezer basket.
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before removing doors. After replacing
doors, connect power.
To avoid possible injury, product, or property
damage, you will need two people to perform the
following instructions.
Materials Needed:
• Phillips screwdriver
To Remove:
right 1. Pull drawer open to full
side
extension.
door
closure
2. Tilt the lower basket forward
and lift to remove.
3. On each white drawer
bracket is a basket cradle
with two snap attachments.
To release each cradle,
unlatch the snaps by
pushing them inward, away
from the side bracket. Lift
the cradles off of the rails.
5 " hex head screws
⁄
16
3 " hex head driver
⁄
8
DANGER
WARNING
CAUTION
" hex head
5
⁄
16
4