Command Buttons - NETGEAR GSM7248NA Administration Manual

3. Enter a new user name in the User Name field.
4. Enter a new user password in the Password field and then retype it in the Confirm Password
field.
Note: If SNMPv3 Authentication is to be used for this user, the password must be
eight or more alphanumeric characters.
5. If you do not need authentication, go to Step 9.
6. To enable authentication, use the Authentication Protocol pulldown menu to select either
MD5 or SHA for the authentication protocol.
7. If you do not need encryption, go to Step 9.
8. To enable encryption, use the Encryption Protocol pulldown menu to select DES for the
encryption scheme. Then, enter in the Encryption Key field an encryption code of eight or
more alphanumeric characters.
9. Click Submit.

Command Buttons

The following command buttons are used throughout the Web interface panels for the switch:
Save
Refresh
Submit
Using the Web Interface
NETGEAR 7000 Series Managed Switch Administration Guide Version 6.0
Pressing the Save button implements and saves the changes you
just made. Some settings may require you to reset the system in
order for them to take effect.
Pressing the Refresh button that appears next to the Apply button
in Web interface panels refreshes the data on the panel.
Pressing the Submit button sends the updated configuration to the
switch. Configuration changes take effect immediately, but these
changes are not retained across a power cycle unless a save is per-
formed.
v1.0, Jan 2007
4-3