Cisco WS-C4507R Troubleshooting Manual page 19

Troubleshooting guide
Hide thumbs Also See for WS-C4507R:
Table of Contents

Advertisement

r3_4506
Session 1
---------
Type
Source Ports
Destination Ports : Fa3/37
RST-3508
9805_05_2004_c2
RST-3508
9805_05_2004_c2
© 2004 Cisco Systems, Inc. All rights reserved. Printed in USA.
Presentation_ID.scr
Monitoring the CPU on Cisco Catalyst 4500
IOS Supervisors
#sh monitor session 1
: Local Session
:
RX Only
: CPU(Queues: 32)
Encapsulation : Native
Ingress : Disabled
Learning : Disabled
© 2004 Cisco Systems, Inc. All rights reserved.
Ping Latency
Low priority task on the CPU
Response times of 7–10 ms are typical on
an idle switch
Pings through the switch are handled as
ordinary data packets and switched in HW
© 2004 Cisco Systems, Inc. All rights reserved.
C(config)#monitor session 1 source cpu queue ?
<1-32>
SPAN source CPU queue numbers
acl
Input and output ACL [13-20]
adj-same-if
Packets routed to the incoming interface
[7]
all
All queues [1-32]
bridged
L2/bridged packets [29-32]
control-packet
Layer 2 Control Packets [5]
mtu-exceeded
Output interface MTU exceeded [9]
nfl
Packets sent to CPU by netflow (unused) [8]
routed
L3/routed packets [21-28]
rpf-failure
Multicast RPF Failures [6]
span
SPAN to CPU (unused) [11]
unknown-sa
Packets with missing source address [10]
37
37
37
38
38
38

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 4000Catalyst 4500

Table of Contents