Table of Contents
Advertisement
The messages in the lines shown above indicate that the diagnostics software checked the
card type and status, determined that the card installed in slot 2 could run diagnostics,
downloaded the diagnostic software image to the card, and gave it the command to run all
diagnostic tests.
(total/indiv. timeout set to 600/220 sec.)
The message in the line shown above indicates the two timeout values set for diagnostics.
The first timeout is set to 600 seconds, which is the maximum amount of time allowed for
all diagnostic tests to run. The second timeout is set to 220 seconds, which is the maximum
amount of time allowed for any one diagnostic test to run.
Field Diagnostic ****PASSED**** for slot 2
The message in the line shown above indicates that the diagnostic tests run on the card in
slot 2 all passed.
Shutting down diags in slot 2
Board will reload
SLOT 2:%SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GSR-P-MZ), Released Version 12.0(n)GS
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Fri 17-Sep-00 17:58 by ...
Router#
The messages in the lines shown above indicate that the diagnostics software is
automatically terminated and the line card is reloaded and restarted.
With verbose Option
If you set the verbose option, that changes the diagnostics message stream to the console.
As an example, running diagnostics on the line card in slot 2 with the verbose option set
produces a message stream to the console similar to the following (only a partial list of
messages is shown). In the following example message sequence, inserted comments
describe the type of diagnostic activity indicated by the messages.
Loading and Running Diagnostics
Running Diagnostics on the Cisco 12012 6-7
Advertisement
Table of Contents
Troubleshooting
