Operation Guide DQR-300 GENERAL GUIDE Main unit 1 SNOOZE/LIGHT button • Press this button to illuminate the display for about four seconds. • Pressing this button while the alarm is sounding stops the alarm. 2 Alarm Time Set buttons Use these buttons to change the alarm time or current time setting.
Operation Guide DQR-300 Setting the Time and Date Manually Turning the Alarm On and Off • When using the clock in an area that is outside of the range of the transmitter in Mainflingen or in an area where Use the Alarm Mode selector (5) on the side of the clock to turn the alarm on and off, and to select the snooze signal reception is impossible for some reason, you need to manually adjust the time as required.
Page 4
Operation Guide DQR-300 Battery precautions High Temperature and Low Temperature Memory • Keep batteries out of the reach of small children. If a battery is accidentally swallowed, contact your physician • The following data is stored in memory automatically. immediately.
Page 5
Operation Guide DQR-300 HYGROMETER FUNCTIONS • To clear the high humidity and low humidity data memory, press the CLEAR button (9). Both the main unit and the sub-unit are equipped with their own humidity sensors. Humidity data measured by the sub-unit is sent by wireless transfer to the main unit.
Page 6
Operation Guide DQR-300 USING THE WEATHER FORECAST FEATURE A built in pressure sensor makes it possible to forecast upcoming weather over the next 12 hours based on changes in barometric pressure. Note that these forecasts are not absolutely accurate, and are intended for general reference only.