Cisco 761M Installation Manual page 69

Table 5-2 ISDN BRI Cause Values and Cause Messages (continued)
Cause Hex
1 2
Value Value
6 0006
7 0007
16 0010
17 0011
18 0012
19 0013
21 0015
22 0016
26 001A
27 001B
Cause Message Definition
Channel The service quality of the specified channel is
unacceptable insufficient to accept the connection.
Call awarded and The user is assigned an incoming call that is
delivered connected to a channel with an established call.
Normal call Normal call clearing has occurred.
clearing
User busy The called system acknowledges the connection
request, but is unable to accept the call because all
B channels are in use.
No user responding The connection cannot be completed because the
destination does not respond to the call.
No answer from The destination responds to the connection
user (user alerted) request, but fails to complete the connection
within the prescribed time. The problem is at the
remote end of the connection.
Call rejected The destination is capable of accepting the call,
but rejected the call for an unknown reason.
Number changed The ISDN number used to set up the call is not
assigned to any system. (If an alternate address is
assigned to the called equipment, it might be
returned in the diagnostic field of this message.)
Non-selected user The destination is capable of accepting the call,
clearing but rejected the call because it was not assigned to
the user.
Destination out of The destination cannot be reached because the
order interface is not functioning correctly, and a
signaling message cannot be delivered. This
might be a temporary condition, but could last for
an extended period of time. For example, the
remote equipment might be turned off.
Troubleshooting Cisco 700 Series Routers 5-7