Cisco 2505 Getting Started Manual page 18

Step 6 For configuration instructions about using the CLI setup program, see the
Bootup Script and Power-On Self Test" section on page
Mounting the Controller in a Rack
To mount the 2504 controller in a 19-inch equipment rack, you can order an optional Optional Rack
Mount kit (AIR-CT2504-RMNT).
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take
special precautions to ensure that the system remains stable. The following guidelines
are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack. Statement 1006
To install the controller in a rack, follow these steps.
Attach the 19-inch brackets to each side of the controller as shown in
Step 1
flat head screws provided in the kit.
18
"Running the
23.
Figure 9 with #10-32