Cisco 2505 Getting Started Manual page 16

Warning Read the wall-mounting carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous
situation to people and damage to the system. Statement 378
To mount the controller on a wall using mounting screws, follow these steps:
Step 1 Mark the location of the mounting screws on the wall. Use the mount hole locations on the
back of the controller for placement of the mounting screws
shown in Figure 7
Figure 7 Mounting Screw Holes on the Back of the Controller
Use a 0.107-inch (2.7mm) or #32 drill bit to drill a 3/4 inch (19mm) hole for the two mounting
Step 2
screws.
Insert two screws into the screw holes and tighten until the top of the screws are 1/8 inch from
Step 3
the wall (leaving enough room for the back panel to slide onto the screws firmly).
16
with a cross-hatch mark.)
5.5
FRONT PANEL
(Figure 7). (The mount holes are