Dell Dimension 5150 Owner's Manual page 112

Power Management
AC Recovery
(Off default)
Auto Power On
(Off default)
Auto Power Time
Suspend Mode
(S3 default)
Maintenance
SERR DMI Message
(On default)
Load Defaults
Event Log
112
Appendix
Determines how the system responds when AC power is re-applied after a
power loss.
• Off — The system remains off when power is re-applied. You must press
the front-panel power button before the system turns on.
• On — The system turns on when power is re-applied.
• Last — The system returns to the last power state the system was in just
before it was turned off.
Sets the computer to automatically turn on.
• Off — disables the Auto Power On feature
• Everyday — turns the computer on every day at the time set in Auto Power
Time
• Weekdays — turns the computer on every day from Monday through
Friday at the time set in Auto Power Time
NOTE:
This feature does not work if you turn off your computer using a power
strip or surge protector.
Sets time to automatically turn on the computer.
Time is kept in the standard 12-hour format (hours:minutes). Change the
startup time by pressing the right- or left-arrow key to increase or decrease
the numbers, or type numbers in both the date and time fields.
Sets the computer's suspend mode.
• S1 — sets the computer to a suspend state where the computer is running
in a low-power mode
• S3 — sets the computer to a standby state where the power is reduced or
turned off for most components; however, system memory remains active
for both settings
Controls the SERR DMI message mechanism.
NOTE:
Some graphics cards require that the SERR DMI message mechanism
be disabled.
Restores System Setup options to their factory defaults.
Allows you to view the Event Log. Entries are marked R for Read and U for
Unread. Mark All Entries Read puts an
Log clears the Event Log.
R to the left of all entries. Clear