Wall Mounting The Sbv5322 - Motorola SBV5322 SURFBOARD DIGITAL VOICE MODEM Installation Manual

Installation

Wall Mounting the SBV5322

If you mount your SBV5322 on the wall, you must:
•
Locate the unit as specified by the local or national codes governing residential or
business cable TV and communications services.
•
Follow all local standards for installing a network interface unit/network interface device
(NIU/NID).
When using the wall mount on drywall or similar material, use anchors for added stability.
To mount your SBV5322 on the wall:
If present, remove the four rubber chassis feet on the bottom of the SBV5322.
1
Print the "Wall Mounting Template"
2
template with a ruler to ensure that it is the correct size as indicated on the template.
Use a center punch to mark the center of the holes.
3
On the wall, locate the marks for the mounting holes.
4
Caution
Before drilling holes, check the structure for potential damage to water,
gas, or electric lines.
See step 7 for recommended mounting hardware size. Drill holes to a depth and
5
diameter appropriate for the size and type of hardware you have selected.
If necessary, install an anchor in each hole.
6
Use M4 x 38 mm (#8 x 1 1/2 inch) screws with a flat underside and maximum screw
head diameter of 9.0 mm (0.35 inches) to mount the SBV5322.
on page 26 at 100% scale. Measure the printed
24 —
SBV5322 SURFboard Digital Voice Modem