®
PhotoCapture Center
For Network Users
a
Put a memory card or USB Flash memory drive into your machine.
b
Start your browser software in which FTP is supported. Your browser software accesses the media using
the FTP protocol and the network Host Name of the machine. You can also access the media by entering
ftp://XXX.XXX.XXX.XXX (where XXX.XXX.XXX.XXX is the IP address of your Brother machine) from
your web browser.
c
Click the name of the file you want to see.
Note
Using certain characters or symbols in a file name on the memory card or USB Flash memory may cause
a problem accessing the file. We recommend to only use combinations of the following characters in a file
name.
1234567890
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
! # $ % & ' ( ) - , @ ^ _ ' { } ˜
When you take out a memory card or USB Flash memory drive, do the following to prevent damage
to the memory card or USB Flash memory drive:
a
Close the browser.
b
Wait until the
Flash memory drive.
CAUTION
DO NOT take out the memory card or USB Flash memory drive while Photo Capture is blinking to avoid
damaging the card, USB Flash memory drive or the data stored on them.
If you take out the memory card or USB Flash memory drive while the Photo Capture key is flashing, you
must restart your computer at once before putting the same memory card or USB Flash memory drive into
the machine. If you do not restart your computer, the data on your media may be destroyed.
(Photo Capture) key stops blinking before taking out the memory card or USB
6
6
6
109