Switching The Speaker Impedance; Changing The Tv Format Setting; Specifications - Pioneer VSX-917V-S Operating Instructions Manual

13 Additional information
Switching the speaker
impedance
We recommend using speakers of 8 Ω with
this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6 Ω impedance rating.
With the receiver in standby, press 
•
STANDBY/ON while holding down the
SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6 Ω.
• SP 8 OHM – Use this setting if your
speakers are rated at 8 Ω or more.

Changing the TV format setting

If the System Setup menu is not displayed
correctly, it may be that the TV system is set
incorrectly for your country or region.
With the receiver in standby, press 
•
STANDBY/ON while holding down the
SIGNAL SELECT button.
The display shows the new setting (PAL or
NTSC).
68
En

Specifications

Amplifier section
• Continuous power output (stereo)
Front . . . . . . . . . . . . . . . . . . . . . . . 100 W + 100 W
(DIN 1 kHz, THD 1.0 %, 8
• Rated power output
(surround / 20 Hz to 20 kHz, THD 0.08 %, 8 Ω)
Front . . . . . . . . . . . . . . . . . . . . . .90 W per channel
Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90 W
Surround. . . . . . . . . . . . . . . . . . .90 W per channel
Surround Back . . . . . . . . . . . . . .90 W per channel
• Rated power output
(surround / 1 kHz, THD 1 %, 8 Ω)
Front . . . . . . . . . . . . . . . . . . . . .110 W per channel
Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W
Surround. . . . . . . . . . . . . . . . . .110 W per channel
Surround Back . . . . . . . . . . . . .110 W per channel
Audio section
• Input (Sensitivity/Impedance)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT. . . . . . . . . . . . . . . .200 mV/47 k
• Frequency response
CD, DVR/VCR, CD-R/TAPE/MD, DVD/LD,
TV/SAT. . . . . . . . . . . . . . . 5 Hz to 100 000 Hz
• Output (Level/Impedance)
DVR/VCR REC, CD-R/TAPE/
MD REC . . . . . . . . . . . . . . . . . . . . . 200 mV/2.2 k
• Tone control
Bass . . . . . . . . . . . . . . . . . . . . . . . .±6 dB (100 Hz)
Treble . . . . . . . . . . . . . . . . . . . . . . .±6 dB (10 kHz)
Loudness . . . . . . +10 dB/+5 dB (100 Hz/10 kHz)
• Signal-to-Noise Ratio DIN (Continuous
rated power output / 50 mW)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT. . . . . . . . . . . . . . . . . 88 dB/64 dB
Video Section
• Input (Sensitivity/Impedance)
DVR/VCR, DVD/LD, TV/SAT................ 1 Vp-p/75
• Output (Level/Impedance)
DVR/VCR, MONITOR OUT.................. 1 Vp-p/75
Ω
Ω
dB
Ω
(at volume level –50 dB)
Ω
Ω
)