Honeywell RUVLAMP2 Owner's Manual page 5

CENTER OF 2 IN. (51 MM)
HOLE FOR LAMP
3/32 IN. (3 MM) PILOT HOLES
FOR MOUNTING SCREWS
4. Use a 3/32 in. drill to provide pilot holes for the mounting
screws.
5. Be sure the duct surface is flat after all holes are drilled.
6. Position the entire base unit on the duct. Be sure the
bulb holes in the duct align with those in the unit to allow
bulb insertion.
Fig. 4. Ultraviolet System template.
7. Install the unit on to the duct using the two no.10, 2 in.
8. Tighten the screws so the space between the case and
5
ALIGN EITHER OF THESE LINES
AS CLOSE AS POSSIBLE TO
DUCT CENTER LINE
Phillips head sheet metal mounting screws provided.
duct is sealed.
ULTRAVIOLET SYSTEM
M18991
69-1859EFS—01