Advertisement
Quick Links
XAG P100 2022 MAINTENANCE INSTRUCTION & NOTICE - 28/10/2022
When the XAG P100 RPA is operating under load during the flight, the flight vibration may cause the
screws joining the motor connector and insulator hub assembly to become loose. The spacing between
the connector and insulator may cause a short circuit resulting in a power surge and excessive heat
generated. The result may include melting deformation of the plastic Hub/Assembly.
Mandatory Maintenance Schedule – Manufacturer Maintenance Advice
Instructions on how to check and maintain the motor connectors/hub assembly are as follows:
01 Unscrew the four screws that tightened the red bumper/navigation light and then remove the
bumper.
XAG Australia
ABN 56 614 943 118
Unit 5, 11 Jullian Cl.
Banksmeadow NSW 2019
P.
+61 (2) 9168 7918
E.
info@xagaustralia.com.au
www.xagaustralia.com.au
Advertisement
Related Manuals for XAG P100
Summary of Contents for XAG P100
- Page 1 XAG P100 2022 MAINTENANCE INSTRUCTION & NOTICE - 28/10/2022 When the XAG P100 RPA is operating under load during the flight, the flight vibration may cause the screws joining the motor connector and insulator hub assembly to become loose. The spacing between the connector and insulator may cause a short circuit resulting in a power surge and excessive heat generated.
- Page 2 XAG Australia ABN 56 614 943 118 Unit 5, 11 Jullian Cl. Banksmeadow NSW 2019 +61 (2) 9168 7918 info@xagaustralia.com.au www.xagaustralia.com.au 02 Use a screwdriver to release the connector protector. 03 Use a screwdriver to release the 3 screws that tighten the connectors and check the insulator and...
- Page 3 XAG Australia ABN 56 614 943 118 Unit 5, 11 Jullian Cl. Banksmeadow NSW 2019 +61 (2) 9168 7918 info@xagaustralia.com.au www.xagaustralia.com.au 04 Replace any insulator that is deformed. Ensure every connector has got an insulator installed.
- Page 4 XAG Australia ABN 56 614 943 118 Unit 5, 11 Jullian Cl. Banksmeadow NSW 2019 +61 (2) 9168 7918 info@xagaustralia.com.au www.xagaustralia.com.au 05 After inspection and cleaning, install ESC connectors correctly and ensure all the connectors are in line with the isolation hub.
- Page 5 XAG Australia takes no responsibility for operators who fail to comply with this advice. Kind regards, XAG Australia After-Sales Support Team Contact your local supplier or a XAG-authorized dealer if you have any problems or questions. XAG Australia Support Hotline: +61 2 9168 7918 (Australia Only) XAG Australia Support Email:...