Troubleshooting - Philips CT1218-FBUU10IH Manual

Table of Contents

Advertisement

Troubleshooting

PROBLEM
The phone does
not switch on
The display shows
BLOCKED
when
you switch on
n
q
The
and
symbols are not
displayed
The display doesn't
respond (or
responds slowly) to
key pushes
Your phone doesn't
go to idle screen
Your phone doesn't
display the phone
numbers of callers
You can't send text
messages
When charging,
the battery icon
shows no bars,
outline is flashing
26
Remove and reinstall the battery (see page 3). Then charge the
phone until the battery icon has stopped flashing. Finally, unplug
from the charger and try to switch the mobile on.
Somebody tried to use your phone but didn't know the PIN code
nor the unblocking code (PUK). Contact your service provider.
The network connection is lost. Either you are in a radio shadow
(in a tunnel or between tall buildings) or you are outside the
network coverage area. Try from another place or contact your
operator for assistance or information about the network.
The display responds more slowly at very low temperatures. This
is normal and does not affect the operation of the phone. Take the
phone to a warmer place and try again.
In other cases please contact your phone supplier.
Make a long press on
SIM card and battery are installed correctly, and switch it on again.
This feature is network and subscription dependent. If the network
doesn't send the caller's number, the phone will display
instead. Contact your operator for detailed information.
Some networks don't allow message exchanges with other
networks. Contact your operator for detailed information.
Only charge the battery in an environment where the temperature
does not go below 0°C (32°F) or above 50°C (113°F).
In other cases please contact your phone supplier.
SOLUTION
e
, or switch off the phone, check that both
Call 1

Advertisement

Table of Contents
loading

Table of Contents