Installing The Heat Sink Assembly; Processor; Removing Processor - Dell OptiPlex 7050 Small Form Factor Owner's Manual

3 To remove the heat sink assembly:
a Disconnect the heat sink assembly cable from the system board [1].
b Loosen the captive screws that secure the heat sink assembly [2] and lift it away from the computer [3].

Installing the heat sink assembly

1 Place the heat sink assembly onto the processor.
2 Tighten the captive screws to secure the heat sink assembly to the system board.
3 Connect the heat sink assembly cable to the system board.
4 Install the:
a optical drive
b 2.5–inch drive assembly
c bezel
d cover
5 Follow the procedure in

Processor

Removing processor

1 Follow the procedure in
2 Remove the:
22 Removing and installing components
After working inside your computer.
Before working inside your computer.