Installing The Intrusion Switch; Storage; Removing 2.5-Inch Drive Assembly - Dell OptiPlex 7050 Small Form Factor Owner's Manual

Installing the intrusion switch

1 Insert the intrusion switch into the slot on the chassis.
2 Connect the intrusion switch cable to the system board.
3 Install the:
a cover
4 Follow the procedure in

Storage

Depending on the configuration you choose, you will have either one 3.5–inch hard drive assembly or two 2.5–inch hard drive assembly.

Removing 2.5-inch drive assembly

1 Follow the procedure in
2 Remove the:
a cover
3 To remove the hard drive assembly:
a Push the release tabs and disconnect the hard drive power cable [1][2].
b Disconnect the hard drive assembly cables from the hard drive [3] [4].
After working inside your computer.
Before working inside your computer.
Removing and installing components 15