Figure 26 Installation Scenario C - ZyXEL Communications IES-5000 Series User Manual

Figure 26 Installation Scenario C

Use the following procedure for this MDF installation scenario.
1 Connect the Telco-50 connector end of the cable you want for DSL service to the Telco-
50 connector labeled USER on the splitter chassis rear panel.
2 Connect the wiring on the other side of the Telco-50 cable to the upper ports of MDF 3
using a punch-down tool.
3 Connect the lower ports of MDF 3 to the upper ports of MDF 2 for those users that want
DSL service. (Users who want telephone service only, retain the original connection from
the top port of MDF 2 to the bottom port of MDF 1.)
4 Connect the telephone wiring from the end-user's DSL equipment to the lower ports of
MDF 2.
5 Connect the Telco-50 connector end of the cable you want for phone service to the Telco-
50 connector labeled CO on the splitter chassis rear panel.
6 Connect the wiring on the other side of the Telco-50 cable to the lower ports of MDF 4
using a punch-down tool.
7 Connect the top ports of MDF 4 to the bottom ports of MDF 1 using telephone wires.
8 Connect the top ports of MDF 1 to the telephone company.
Chapter 3 Hardware Installation and Connections
IES-5000 Series User's Guide
45