Adjusting The Shock Absorber Assembly - Yamaha AG200FEB 2011 Owner's Manual

tion, and then tighten the bolts.
3. Install the panels.
TIP
Make sure that the seat is properly se-
cured before riding.
INSTRUMENT AND CONTROL FUNCTIONS
Adjusting the shock absorber
assembly
This shock absorber assembly is
equipped with a spring preload adjust-
ing ring.
NOTICE
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
Adjust the spring preload as follows.
1. Remove the seat. (See page 4-8.)
2. To increase the spring preload and
thereby harden the suspension,
turn the adjusting ring in direction
(a). To decrease the spring pre-
load and thereby soften the sus-
pension, turn the adjusting ring in
direction (b).

Align the appropriate notch in
the adjusting ring with the posi-
tion indicator on the shock ab-
sorber.

Use the special wrench includ-
ed in the owner's tool kit to
make the adjustment.
4-9
EAU36464
1
2
3
4
(a)
5
ECA10101
2
1. Special wrench
2. Position indicator
Spring preload setting:
Minimum (soft):
1
Standard:
1
Maximum (hard):
5
3. Install the seat.
WARNING
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.

Do not tamper with or attempt to
1
2
(b)
3
4
5
6
7
8
EWA10221
9