Installing The Driver - Yamaha UW10 Owner's Manual

Installing the driver

Before you can use the UW10, you need to install the driver on the computer.
The USB audio driver enables you to transfer audio signals between an audio
application on the computer and the UW10 via a USB cable.
computer
application
The UW10 does not work with a USB hub that is powered by the USB bus power
NOTE
supply.
Installing the driver
Follow the instructions below to install the USB audio driver included in the
Windows system, and set up Windows as needed.
Close all applications and windows on the computer, and disconnect the computer
NOTE
from the network and the Internet.
Disconnect all devices that are connected to the UW10's jacks, except for the USB
NOTE
connector.
Disconnect all USB devices, except for the UW10, from the computer. Connect the
NOTE
UW10 directly to the computer's USB connector, not via a USB hub.
Check the drive name (D:, E:, Q:, etc.) of your CD-ROM drive, which is listed below the
NOTE
CD-ROM icon in My Computer.
If the driver for another USB audio device has already been installed, you can use that
NOTE
driver for the UW10.
You need the ASIO driver software to use applications that support ASIO. Refer to the
NOTE
"ReadMe.html" file located in the "English" folder in the "ASIOdrv_" folder for
information on installing the driver software.
Windows 98/98SE users→page 17
Windows Me users→page 20
Windows 2000/XP users→page 20
16
UW10 Owner's Manual
audio
driver
audio data
USB cable
SOURCE SELECT
DIGITAL
INPUT
TRACK DOWN
UW10
IN OUT L R L R
DIGITAL INPUT OUTPUT
USB-AUDIO INTERFACE
14