Advertisement
Adjusting Audio
Adjusting Volume
Turn the control [20] to the right to raise the
volume. Turn the control to the left to lower
the volume.
Adjusting the Fader
Turn the control [21] upward to fade sound
in the rear speakers. Turn the control down-
wards to fade sound in the front speakers.
* With a 2 speaker system, set the control
in acentral position.
Adjusting Bass
Turn the control [1] to the right to increase
bass. Turn the control to the left to de-
crease bass.
Adjusting Treble
Pull the control [1] towards you until it
clicks. Turn the control to the right while it
is in this position to increase treble. Turn it
to the left to decrease treble. After adjusting
the control, push it back to its original posi-
tion.
Adjusting Balance
Pull the control [20] towards you until it
clicks. Turn the control to the right while it
is in this position to fade sound in the left
speaker. Turn it to the left to fade sound in
the right speaker. After adjusting the con-
trol, push it back to its original position.
Using the Loudness Function
Press button [18] and the "LOUD" indicator
will appear on the display. This "loudness"
function enhances both the high and low
rariges of sound lo give even More power
to output even at low volumes.
Using the Radio
Parts Identification
(Fig. 1)
[4] Preset
{6] Band
[7] Tuning/Local Seek Sensitivity/Seek,
Manual
[12] Source Selector
{13] Best Stations Memory (BSM)
[15] Local Station
{16] Preset Scan
[17] FM Stereo/Mono
[19] Display
(Fig. 2)
[22] Local Station
[23] Seek
[24] Preset Scan
[26] Preset Number
[27] FM Mono
[28] FM Stereo
[29] Frequency
[30] Band
Listening to the Radio
KEH-M5550
The unit incorporates priority cassette tape
play. The unit will not switch to radio play
while a tape is inserted, so be sure to eject
the tape when you wish to listen to the ra-
dio.
1.Press button [12] to switch the radio
power on.
Press button [12] to switch the tuner on and
off. Oprerations will be different when the
unit is combined with a seperately available
multi-play CD player (CDX-M30, etc.). For
details on "Switching Power ON" refer to
the relevent clause, on page 6.
2.Press button [6] to select a band.
r IFIP or
(FM1)
(FM2)
(FM3)
(AM)
3.Use seek tuning to tune in a frequency.
Confirm that the SEEK indicator [23] is
shown on the display (if not, press the (+)
and (-) sides of button [7] at the same
time). Press the (+) side of button [7] to au-
tomatically tune in the next higher receiv-
able frequency, and the (—) side for a lower
frequency.
4.Adjust volume and tone (see page 6).
5.Assign the tuned frequency to one of the
buttons in Bank [4] (preset memory).
Press and hold down one of the button in
Bank [4] for at least two seconds. The fre-
quency is assigned to the selected button
when the preset number [26] stops flashing
on the display. Up to 18 FM stations (6 each
for FM1, FM2 and FM3), and six AM sta-
tions can be assigned to the preset memory
buttons in Bank [4].
Advertisement
