Editing The Dr/Pc Native Part Parameters - Yamaha PLG150-DR Owner's Manual

Editing the DR/PC Native Part Parameters

The following explanations show how to edit the DR/PC native part parameters when creating PLG
voices, using the MOTIF Control Synthesizer as an example. For information on storing the PLG
voices with your particular Modular Synthesis Plug-in System compatible instrument, refer to the
owner's manual of that instrument.
Keep in mind that the parameter values and settings below represent offsets of the actual voice settings. This
NOTE
means that adjustments made to the parameters may not make much change in the actual sound, depending on
the original settings of the voice. For parameter values, a setting of "0" results in no change, while positive and
negative values increase and decrease the value respectively.
1
Select the desired DR/PC voice, as described in "Selecting DR/PC Voices"
on page 8.
2
Enter the Voice Edit mode.
Press the [EDIT] button.
3
Select an element to be edited.
1) Press any one of the NUMBER buttons ([1] - [4]) to edit the element parameters.
2) Press the [F4] button to select the "NATIVE" element.
4
Select the desired parameter.
Use the cursor buttons to select the desired parameter.
NOTE
5
Adjust the value or change the setting for the selected parameter.
Use the [INC/YES] and [DEC/NO] buttons or the data dial.
For a list of available parameters, see page 13.
For Modular Synthesis Plug-in System Users
9