Table of Contents
Advertisement
• Src1 (FM Depth Ctrl)
Settings: Fixed, PEG, FEG, LFO1, LFO2
This determines the modulation source which controls the
"Fixed," there is no change in modulation over time.
• Src2 (Modulator)
Settings: VCO2 Frequency, VCO1, VCO1 Sub Osc. (sub oscillator), PEG,
FEG, LFO1, LFO2, VCO2 Output
This determines the source wave which modulates the VCO1 wave.
• For the most part, the above settings should be self-explanatory. If necessary, refer to the rel-
evant sections (for example, VCO1, PEG, FEG, LFO1/2). The other settings are explained
below.
VCO2 Frequency :
VCO1 Sub Osc. :
VCO2 Output :
Output Gain
Settings: +0 dB, +6 dB, +12 dB
This determines the overall level gain of the output signal of the selected pattern. Use
this parameter together with the hardware VOLUME control on the tone generator to set
the desired pattern level.
• Be careful when using the higher settings, since you may inadvertently damage the con-
nected audio equipment (and your ears!) if the pattern is too loud.
This modulation uses a sine wave which is set to the same frequency as
that of the VCO 2's pitch.
This modulation uses a wave of either half or double the frequency of the
VCO 1 (depending on the selected VCO 1 waveform).
This uses the actual VCO 2 output waveform for modulation, resulting in
an FM synthesis-like sound.
45
Parameters /
Detail Parameter Tab
FM
Depth. When this is set to
Advertisement
Table of Contents
