AEG BPS355061M User Manual page 21

4. Put the door on a soft cloth on a stable
surface.
5. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
2
B
6. Pull the door trim to the front to remove it.
7. Hold the door glass panels by their top
edge and carefully pull them out one by
one. Start from the top panel. Make sure
the glass slides out of the supports
completely.
8. Clean the glass panels with water and
soap. Dry the glass panels carefully. Do
not clean the glass panels in the
dishwasher.
9. After cleaning, install the glass panels
and the oven door.
If the door is installed correctly, you will hear
a click when closing the latches.
Make sure that you put the glass panels (
and ) back in the correct sequence. Check
for the symbol / printing on the side of the
glass panel. Each of the glass panels looks
on the top edge of
1
different to make the disassembly and
assembly easier.
When installed correctly, the door trim clicks.
A B
Make sure that you install the middle panel of
glass in the seats correctly.
12.7 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
A
B
ENGLISH 21