Table of Contents
Advertisement
Troubleshooting guide
The following check help you remedy most problems that you may encounter with your unit.
Before going through the checklist below, check the connection and operating procedures.
General
Provlem
No sound
Cause/Solution
¢ Rotate the dial in a clockwise direction to adjust the volume.
* Set the fader control to the center position for 2-speaker
systems.
The contents of the memory
have been erased.
¢ The power cord or battery has been disconnected.
¢ The reset button has been pressed.
—+ Store again into the memory.
Indications do not appear in
the display.
Remove the front panel and clean the connectors. See "Cleaning
the connectors" (page 25) for details.
Tape playback
Problem
Playback sound. is distorted.
Cause/Solution
Contamination of the tape head. + Clean the head.
The AMS does not operate
correctly.
-
¢ There is a noise in the space between tracks.
« A blank space is too short (less than four seconds).
eR Pt on
is pressed immediately before the
following tracks.
eo KEK on
is pressed immediately after the track
starts.
¢ A long pause, or a passage of low frequencies or very low
sound level is treated as a blank space.
Radio reception
Problem
Preset tuning is not possible.
Automatic tuning is not
possible.
Cause/Solution
* Memorise the correct frequency.
* The broadcast is too weak.
The broadcast is too weak.
—+ Use manual tuning.
The "STEREO" indication
flashes.
DSP functions
¢ Tune in the frequency correctly.
* The broadcast signal is too weak.
—+ Set to the.monaural mode (page 8).
Problem
No sound, or sound is too low.
Cause/Solution
The volume of the rear speakers may have been automatically
lowered in order to maximize the effect of the listening position
adjustment.
— Rotate the dial in a clockwise direction to adjust the balance.
The speaker balance can be set separately for the DSP on
mode and DSP off mode (page 20).
UOIEWIOJU|
|EUOIIPPV
2]
29
Advertisement
Table of Contents
