Table of Contents
Advertisement
20
5 press
@ (—).
=LP I=
7reas
Renee F
6 Rotate the dial to adjust the center of
the sound field to the front or rear.
Center moves to the R (rear)
Center moves to the F (front)
7 Press
for two seconds.
When the effect setting is complete, the
normal playback mode display appears.
Adjusting the fader (FAD)
Normally, with the DSP mode on, the volume
of the output sound from the rear speakers is
lowered automatically to improve the
efficiency of the listening position setting. If
you want to raise the rear speaker volume,
adjust the fader.
1 Follow steps 1 to 3 of "Selecting a
surround menu" (page 18).
2 Press
momentarily until "FAD"
appears.
3 Rotate the dial to adjust the fader.
Decreases front speaker volume
Increases front speaker volume
After three seconds, the display goes back
to the normal playback mode.
Adjusting the volume of
the subwoofer(s)
1 Press
to select a source (radio,
tape, CD, or MD).
2 Press
repeatedly until "SUB"
appears.
3 Rotate the dial to adjust the volume.
After three seconds, the display goes back
to the normal playback mode.
- Adjusting the frequency of the
subwoofer(s)
To match the characteristics of the connected
subwoofer(s), you can cut the unwanted high
and middle frequency signals entering the
subwoofer(s). By setting the cut-off frequency
(see the diagram below), the subwoofer(s) will
output only low frequency signals so that you
can get a clearer sound image.
Level
Cut-off frequency
62
125
198
Frequency (Hz)
1 Press
to select a source (radio,
tape, CD, or MD).
2 Press
for two seconds.
3 Press
repeatedly until "SUB"
appears.
wt,
SUE
C.off125HzZ
i
4 Rotate the dial to select the desired cut-
off frequency.
The cut-off frequency in the display
changes.
5 Press
for two seconds.
When the frequency setting is complete, the
display goes back to the normal playback
mode.
Advertisement
Table of Contents
