World Time City Setting; Swapping Your Home Time And World Time; Alarm; Configuring Alarm Settings - Casio GW-M5610U Operation Manual

World Time City Setting

You can specify up to five cities as your World
Time favorites. If you are in an area that
observes summer time, you can also enable
or disable summer time.
1.
Enter the World Time Mode.
Navigating Between Modes
l
2.
Use (D) to display the World Time number
whose setting you want to configure.
3.
Hold down (A) for at least two seconds.
This causes [WT] to flash on the display.
4.
Use (B) and (D) to display the city you want
to specify as a World Time City.
Holding down (B) or (D) scrolls through
●
settings at high speed.
5.
If you want to change the summer time
setting, press (C).
6.
Use (D) to select a summer time setting.
[OFF]
●
The watch always indicates standard
time.
[ON]
●
The watch always indicates summer
time.
7.
Press (A) to complete the setting
operation.
Watch Operation Guide 3495
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
While [UTC] is selected as the city, you
●
will not be able to change or check the
summer time setting.
The summer time setting you configure
●
is applied to the currently selected city
only. It does not affect other cities.
Swapping Your Home Time
and World Time
In the World Time mode, press (A) and (B) at
the same time to swap your Home City time
with your World Time.
Before swapping
Home Time
World Time
The watch will beep when the alarm time is
reached. You can configure up to four
standard daily alarms, and one daily alarm
with snooze. The hourly time signal causes the
watch to beep every hour on the hour.
Snooze causes the alarm to sound up to
●
seven times, at five-minute intervals.
The alarm sound is muted in the cases
●
described below.
When battery power is low
ー
When watch is at Level 2 power saving
ー
l
After swapping
World Time

Configuring Alarm Settings

Home Time
1.
Enter the Alarm Mode.
l
2.
Use (D) to display the alarm screen (alarm
number [1] to [4] or [SNZ]) whose setting
you want to change.
3.
Hold down (A) for at least two seconds.
This causes the hours digits to flash.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.

Alarm

Power Saving Function
Navigating Between Modes
Alarm number
Alarm time
Hours
13