Smart Card Module; Removing The Smart Card Module - Dell Latitude 14 Rugged Extreme Owner's Manual

8. Install the:
a. SIM board
b. WWAN card
c. WLAN card
d. GPS module
e. ExpressCard
f. heat sink
g. GPU module
h. RF holder
i. GPS holder
j. memory module
k. optical drive
l. docking board
m. base cover
n. keyboard
o. keyboard door
p. hard drive or SSD
q. battery
NOTE: When the service technician replaces a system board, he should set the service tag once
the system starts up. This is a one time effort. If you fail to set the service tag, the system battery
will not charge. Therefore, it is very important that the service technician sets the correct
system service tag. If a wrong service tag is set, there is no way to reset it and the technician
will have to place order for another system board.
9. Follow the procedure in

Smart card module

Removing the Smart card module

1. Follow the procedure in
2. Remove the:
a. battery
b. hard drive or SSD
c. keyboard
d. base cover
e. docking board
f. optical drive
g. memory module
h. GPU module
i. heat sink
j. ExpressCard
k. GPS module
l. WLAN card
m. WWAN card
n. SIM board
o. system board
3. To remove the Smart card module:
a. Lift the release tab and disconnect the smart card ribbon cable from the USH board [1,2].
After working inside your
Before working inside your
computer.
computer.
47