Maintenance Menu; Composition Of Maintenance Menu - Fujitsu CT114 Instruction Manual

Maintenance Menu

Composition of Maintenance Menu

The cleaver provides the ability for users to perform routine maintenance. This section
describes how to use the maintenance menu to maintain your cleaver.
1. Press the DOWN key from the [READY] or [RESET] state to enter the main
menu.
2. Navigate to third and fourth tabs to display the [Maintenance Menu].
3. Select a function to perform by pressing the SET key.
Item
Touchscreen Calibration
Blade Adjustment
Blade Replacement
Fiber Holder Adapter Installation
Fiber Position Confirmation
Diagnostic Test
Blade Management
Fiber Holder Management
Guide
Maintenance Info.
Description
Calibrates Touchscreen.
Follow the on-screen instructions to perform calibration.
Performs the blade position adjustment.
This function is used when replacing the cleaver blade.
This function is used to install the Fiber Holder Adapter.
This function is used to confirm the left and right clamp
alignment positions.
Built-in diagnostic test is performed.
This function is used to both change the blade position
and confirm the cleave count at each blade position.
This function is used to register new fiber holders and to
view the registered fiber holder.
This function shows the built-in instruction manual.
Maintenance information and general information about
the cleaver is shown.
CT114_Rev
2
62