Advertisement
PANNIER CASE (ALUMINUM)
PANNIER
CASE
• The weight of the cargo must not exceed the
following maximum weight capacity:
Each pannier case 10.0 kg (22.0 lb)
• Load weight equally on both sides to minimize
imbalance. If the weight is not loaded equally
on both sides or if it exceeds the maximum
weight capacity of this accessory, handling
is proportionally affected, resulting in serious
accident or injury.
• Do not store valuables or fragile articles in the
pannier cases.
• Be sure that the pannier cases are installed
securely before riding.
• Before riding, confirm that lid is closed and
remove the key.
• To prevent burns, allow the engine, exhaust
system, radiator, etc., to cool before installing and
removing the accessory.
• The pannier case is hot while the engine is
running and after it has been stopped (after riding
etc.).
Especially the lower part of the pannier case
on the right side is close to the muffler and thus
becomes very hot, for that reason it should not be
touched for some time.
• The pannier cases are not perfectly watertight,
and water may enter when washing the
motorcycle, when it rains, etc.
• Always install pannier cases on both the left and
the right side.
• Don't place a heavy object on the opened lid or
apply an excessive force from the top of opened lid.
• Open and close the lid gently.
• If the pannier case gets dirty, slightly push and
clean it with a sponge or a shop towel moistened
with a neutral detergent, remove the detergent
with clean water, and then wipe them dry with a
clean sponge or shop towel.
• Never use organic solvents such as gasoline,
thinner and benzine to clean this accessory. Also
do not use acid or alkaline cleaners to clean this
accessory.
Wipe up spilled brake or battery fluid at once as
they may damage the surface.
• The surface treatment is not processed on the
aluminum part to obtain the original texture for
this product. The rust may occur depending
on the usage circumstances or maintenance
conditions. When it gets dirty, make sure to avoid
leaving and provide care because it easily gets
dirty such as dirt with the hands or incrustations.
CRF1100A/A2/A4/D/D2/D4
Genuine Accessory User's Guide
LEFT PANNIER STAY
BOSS
PANNIER
LEVER
CASE
INDICATOR
PANNIER
CASE
HOW TO INSTALL THE PANNIER CASES
CAM
1. Install the pannier case as shown.
• First install the two bosses, then install the
two cams.
• Installation can be done with the key
position is in lock or unlock.
• Installation can be done without inserting
the key.
• When the pannier case can not be
installed, operate the lever and reinstall it.
2. Make sure that the indicators in front and
behind the pannier stay are green.
• When the indicator is red, the pannier
case is not securely installed. Remove the
pannier case and reinstall it.
3. If the key is inserted, pull it out and install the
cap.
4. Check that the pannier case is installed
securely by swinging the pannier case taking
care not to fall the motorcycle down.
• The pannier case can come off during
riding unless it is mounted securely.
7 of 22
Advertisement
