Table of Contents
Advertisement
9.
With another person to help steady machine,
lift machine just enough to clear pallet, then
remove pallet and lower machine to ground.
10. Loosen hex nuts from Step 7, adjust lower
hex nuts on machine feet until machine is
level, then tighten upper hex nuts to secure.
11. Remove (3) Phillips head screws and flat
washers shown in Figure 12 to remove disc
guard.
Disc Guard
Figure 12. Location of disc guard and fasteners.
12. Loosen (2) table tilt lock handles, adjust
table tilt to 0°, then tighten lock handles (see
Figure 13).
Table Tilt
Lock Handle
(1 of 2)
Figure 13. Table tilt adjusted to 0°.
Model G0967 (Mfd. Since 06/23)
13. Loosen (6) cap screws shown in Figure 14,
then move table away from steel disc.
x 3
Figure 14. Location of table cap screws.
14. Clean steel disc surface with cleaner/
degreaser and let dry.
15. Peel back protective layer on one-half of
sanding disc and fold it against remaining
half.
16. Slip half with protective layer between disc
and table edge (see Figure 15).
Table
Figure 15. Example of installing sanding disc.
x 6
-17-
Advertisement
Table of Contents
