Table of Contents
Advertisement
Disconnect
faulty
4.
from wire crimp connectors (see Figure
78), then fully remove laser module from
electrical box.
Wire Crimp
Connectors
2
1
Laser
Module
Wires
Figure 78. Laser module wiring.
Insert new laser module cord and wires
5.
through hole in electrical box, and attach
wires to wire crimp connectors as they were
connected in Step 4. Wrap wires at crimp
connectors with electrical tape so they will not
come loose during operation.
Feed new laser module back into electrical
6.
box, and install electrical box cover.
Refer to Adjusting Laser Guide on Page
7.
34 to secure and adjust laser modules.
Replacing LED
Items Needed
Phillips Head Screwdrivers #1, #2 ...............1 Ea.
Hex Wrench 4mm .............................................. 1
Wrench or Socket 8mm ..................................... 1
Replacement LED Assembly (#PT33961195) ... 1
Electrical Tape ................................... As Needed
To replace LED:
DISCONNECT MACHINE FROM POWER!
1.
-50-
laser
module
wires
NO
NC
COM
HEADSTOCK
2
1
Laser
Switch
Qty
2
Remove (5) Phillips head screws to remove
2.
laser module electrical box cover (see
Figure 79).
8
7
x 5
SWITCH BOX
Laser Module
Electrical Box
Cover
Figure 79. Location of laser module electrical
box cover and securing screws.
Disconnect laser module cord wires from
3.
wire crimp connector and laser switch (see
Figure 80).
2
1
Laser
Module
Wires
Figure 80. Laser module cord wires to
disconnect.
Model T33959/60/61 (Mfd. Since 08/23)
NC
1
4
3
NO
NC
COM
Wire Crimp
Connector
HEADSTOC
2
1
Laser
Switch
Advertisement
Table of Contents
