Led - Grizzly T33959 Owner's Manual

Disconnect faulty laser module wires from
7.
wire crimp connector and laser switch (see
Figure 71), then tie string to end of faulty
laser module wires to aid in installation of
new laser module.
Laser
Module
Wires
NO NC
COM
Laser Switch
HEADSTOCK
Figure 71. Laser module wiring.
While keeping hold of untied end of string at
8.
switch box, fully remove faulty laser module
from headstock, pulling wires with it. String
will follow cord path.
Remove string from faulty laser module wires,
9.
and tie it to end of new laser module wires.
10. Pull untied end of string to thread new laser
module wires through headstock, belt cover,
and switch box.
Model T33959/60/61 (Mfd. Since 08/23)
2
Wire Crimp
Connector
8
7
1 2
SWITCH
BOX
11. Untie string and attach new laser module
wires to crimp wire connector and laser
switch as they were connected in Step 7.
Wrap wires at crimp connector with electri-
cal tape so they will not come loose during
operation.
12. Install switch box and close belt cover.
13. Feed new laser module cord and laser mod-
ule into headstock.
14. Refer to Adjusting Laser Guide on Page
34 to secure and adjust laser modules.
NC 1
Replacing LED
Items Needed
Phillips Head Screwdriver #2 ............................ 1
Replacement LED (#PT33959051) .................... 1
String (3' Minimum) ............................................ 1
Electrical Tape ................................... As Needed
4
3
To replace LED:
DISCONNECT MACHINE FROM POWER!
1.
1
2
Turn LED in mount until it releases from
2.
mount (see Figure 72).

LED

Mount
Figure 72. Location of LED and LED mount.
LED
Qty
-47-