Table of Contents
Advertisement
DINION 7100i IR
Local storage
To activate the ANR settings, Recording 1 must be assigned to an iSCSI target and Recording
2 to a local storage.
This function enables recording to the iSCSI target. If there is a network disconnection, the
video is recorded to the local storage. When the network is recovered, the video recorded to
the local storage is transferred to the iSCSI target and completes the missing information.
Dual micro SD
When two micro SD cards are installed, they can be combined to function in these modes:
–
–
–
The recording settings of the recording tracks Rec. 1 and Rec. 2 can be configured under
Recording Profiles.
When using Redundant mode, the two recording tracks are used, so it is not possible to use
the iSCSI Media or VRM recording in parallel.
Activating and configuring storage media
Available media or iSCSI drives must be transferred to the Managed storage media list,
activated, and configured for storage.
Note:
An iSCSI target storage device can only be associated with one user. If a target is being used
by another user, ensure that the current user no longer needs the target before decoupling
that user.
1.
2.
3.
Deactivating storage media
A storage medium in the Managed storage media list can be deactivated. It is then no longer
used for recordings.
1.
2.
Bosch Security Systems B.V.
Redundant: The two micro SD cards record the same data, for redundancy purposes.
–
On the first micro SD card, select recording track Rec. 1 or Rec. 2.
–
On the second micro SD card, select the other recording track.
Failover: One of the micro SD cards can be used as a backup for the other micro SD card.
–
On the first micro SD card, select recording track Rec. 1 or Rec. 2.
–
On the second micro SD card, select the same recording track as the first micro SD
card.
–
With the second micro SD card selected, click Edit and check the Use as failover
checkbox.
Extended: The recording is saved in one micro SD card until it is full and then would be
saved in the other micro SD card. When this last one is full, the recording would go back
to the first one and overwrite the previously saved recording.
–
On the first micro SD card, select recording track Rec. 1 or Rec. 2.
–
On the second micro SD card, select the same recording track.
In the Storage overview section, double-click a storage medium, an iSCSI LUN or one of
the other available drives.
–
The medium is added as a target in the Managed storage media list.
–
Newly added media is shown as Not active in the Status column.
Click Set to activate all media in the Managed storage media list.
–
The Status column shows all media as Online.
Check the box in the Rec. 1 or Rec. 2 column to specify the recording tracks to be
recorded on the target selected.
Click a storage medium in the Managed storage media list to select it.
Click Remove below the list. The storage medium is deactivated and removed from the
list.
User manual
Configuration | en
2023-06 | V02 | F.01U.390.686
37
Advertisement
Table of Contents
