Advertisement
LOCATION AND FUNCTION OF CONTROLS
Note
The CHM-9002/1202 do not have a cabinet enclosure as
depicted for the CPD-9090/1290 models in the
illustration.
However,
the location and function of the controls are
identical
for
both the CHM and CPD models.
CPD-1290
CPD-9090
[JJ
POWER switch and indicator (green)
To turn on the power of the
unit,
press this switch to ON
.
The indicator will light
up.
To turn off the
unit,
press this
switch to
OFF.
80N
~OFF
[I]
PICTURE control
Adjusts the contrast. Turn downwards to increase
contrast,
or upwards to decrease it.
Push upward
to remove panel
[1J
BRIGHTNESS control
Normally keep this control at the center detent position.
For a brighter display', turn this knob clockwise. For a
darker
display,
turn it
counterclockwise.
!1]
H
SHIFT
(horizontal shift) control
If the displays of
microcomputers,
character
generators,
etc. are shifted toward the left or right side of the
screen,
turn this control to center the
displays.
[I]
V
HOLD (vertical hold) control
If the display rolls
vertically,
adjust this control until the
display stabilizes.
[I]
RG
B
input selector
Depending on the RGB output of the equipment you have
connected,
set this switch to one of the following 3
positions.
ANALOG:
For microcomputers and videotex units
having analog RGB output.
DIGITAL 1: For microcomputers having digital RGB
output with positive sync
signals,
such as the IBM
PC,
IBM PCXT.
DIGITAL 2: For microcomputers having digital RGB
output with negative sync
signals.
[]]
AC
power
input connector
Connect to the AC outlet with the supplied AC power
cord.
[I]
RGB IN (input) connector (8-pin)
Allows a
microcomputer,
a character generator or a
videotex unit having either analog or digital output to be
connected.
3
Advertisement
