Table of Contents
Advertisement
Cleaning and Maintenance
Periodical Maintenance and Clean-up
Maintenance should be carried out by trained personnel in accordance with the safety instructions.
Daily Maintenance
•
Washing arms should be disconnected and any debris should be removed using water and a
nylon brush
•
Debris remaining in the washing tank should be removed.
•
Suction filter should be disconnected and cleaned with water.
•
The inside of the tank should be cleaned up with a sponge or cloth and plenty of water.
•
After cleaning operation is finished suction filter, water outlet pipe, scrap filters and washing and
rinsing arms should be reinstalled.
Periodical Maintenance
Periodic maintenance should be carried out by the user at least once in a month, this should be done
when the machine is ready for operation and before the glasses are set up in the machine.
•
Descale the machine by adding descaler to the washing tank and follow descaler instructions (which
may vary depending on brand).
•
After descaling water within the machine should be drained and unit should be refilled with fresh water.
Run the machine for 5 cycles then drain and refill again with fresh water. The machine will now be
ready for operation.
•
If the device is not used for long period of time, you must drain the water left inside the boiler. For
this purpose, let the water drain out after opening the tap (boiler tank tap) at the lower part of the
unit. Leaving water standing inside the unit for long period when not in use may harm you r
machine.
Note
Never use cleaning chemicals containing bleaching agents, chlorine or hypochloride.
•
Never use steel sponge or wire brush for cleaning purposes.
•
Do not use pressurized water to clean inner and outer surfaces of the appliance.
•
Before cleaning the interior of the glasswasher, first carefully remove from the wash tank any parts that
•
may cause injury during cleaning, such as broken glass.
Wipe clean the interior of the glasswasher. Once wastes and particles are removed, re-place
•
the washing/rinsing arms and filters.
Clean the outer surface of the glasswasher with a damp cloth.
•
After drying, clean with a stainless-steel approved sanitizer (e.g. Jantex FS431)
•
Advertisement
Table of Contents
