Table of Contents
Advertisement
Step
1 Preparing
the
power
supply
Use the battery
pack after charging
it for your camcorder.
Your camcorder
operates
only with the "InfoLITHIUM"
battery pack (L series).
"InfoLITHIUM"
is a t_ademark of Sony Corporation.
(11 Open the DC IN jack cover and cormect
the AC power
adaptor
supplied
with
your camcorder
to the DC IN jack with the plug's
• mark facing up.
(2) Connect
the power
cord
to the AC power
adaptor.
(3) Connect
the power cord to a wall outlet.
(4) Set the POWER switch
to OFF. Charging
begins. The remaining
batte D ' time is
indicated
in minutes
on the display
window.
When the remaining
baflery indicator
changes
to Jm, normal charge is completed,
To
fully charge the battery (full charge),
leave the battery pack attached for about
I hour
after normal
charge is completed
until FULL appears in the display window,
Fully
charging
the batte D, allows
you to use the battery longer
than usual.
R
2
Note
Prevent metallic objects from coming into contact with the metal parts of the _
plug of
the AC power adaptor. This may cause a short-circuit,
damaging
the AC power
adaptor.
Remaining battery time indicator
" The remaining
batter), time indicator i_ the display
window
roughly
indicates
the
recording
time with the viewfinder
....
Battery pack
The battery pack is charged
a little before it leaves the factory.
Until your camcorder calculates the actual remaining
battery time
"- - -- rain" appears in the display
window.
Advertisement
Table of Contents
