Sony Hi8 EVV-9000P Manual page 25

CLEAR DERE REPS BRE ERATE ENE SESS ETE SE EEE I ETE ES SOLE TELL ASE LOE EINE EDGE LYE. T L L S E D E R AIOE NN ORS ETP TNE SEE AINE SET ES EI EE
7 Set the POWER switches on the VTR and the
video camera to on.
Insert a cassette.
Point the video camera at the subject, and adjust
the video camera to make it ready for operation.
(Refer to the instruction manual of the video camera.)
Press the VTR button on the video camera or the
lens.
Recording will start.
(But, it takes a few seconds for the servo-
mechanisms to lock in.)
To enter the recording pause mode, press the
VTR button on the video camera or on the lens
during recording.
To stop recording, set the VTR to the recording
pause mode, then press the STOP button on the
VTR.
'Sxzaramansarere stat RIES HN RE MORENO MTC NON SUAS OE RNY SMART IAEA METER EREVAN HU RPO SRO NI
To check the last scene of the
previous recording — Rec review
Set the VTR in the recording pause mode, and press the
REC REVIEW button on the video camera. The tape is
rewound for 2 seconds and the VTR automatically starts to
playback the last scene and stops at the previous position.
Check the recorded picture on the viewfinder and the
recorded sound through the speaker or earphone.
Recording pause mode is resumed.
Note on recording pause mode
If the unit is left in the recording pause mode for about 5
minutes, the unit automatically enters the stop mode in
order to protect the tape.
When the safety tab on the cassette is slid out to prevent
accidental erasure, or the POWER switch on the video
camera is set to OFF, you cannot make a recording.
To record from the beginning of
the tape
Run the tape for about 15 seconds at the beginning of a
cassette before recording. It prevents you from missing the
starting point when starting playback or leaving the
previously recorded portion when recording on the recorded
tape.
To monitor the sound
Monitor the sound through the speaker or the earphone
connected to the EARPHONE jack. Select the monitor
sound with the MONITOR SELECT switch.
2