Disassembly
Removing and Replacing the VGA Camera Assembly
40
1.
Remove the battery door, battery, SIM card, antenna, rear housing, transceiver
PC board assembly, flip bezel, flip cover, and flip PCB assembly as described
in the procedures.
2.
Using the disassembly tool, gently unseat the VGA camera connector and
remove it from the flip display board, as shown in Figure 23.
Figure 23. Removing and Replacing the VGA Camera Assembly
3.
To replace, carefully press the VGA camera assembly into its slot in the flip
assembly.
4.
Gently press the end of the VGA camera assembly flex connector into its socket
connector on the flip display assembly. Avoid damage to the flex cable.
February 02, 2007
VGA camera connector
K3
Disassembly tool
070095o
6809509A88-O