Control Panel; Water Heater Installation - Electrolux EWH 30 GLD ECO EEC User Manual

temperature reaches the set point, the heating
element is automatically switched off.
Levels of water heater protection:
• protection against overheating;
• protection against excessive hydraulic
pressure.
• RCD (Ground Fault Interrupter).
The steel inner tanks with a special protec-
tive coating are made using the advanced
electrostatic dry enameling method. Enamel
properties:
• increased adhesive ability and high ductility
(hardened at 850 °C);
• expands or contracts with temperature
changes in the same proportion as the
walls of the inner tank, without creating
micro-cracks that could lead to corrosion.
As additional protection against corrosion of
the internal tank, the water heater is equipped
with a magnesium anode. The dry heating
element (PHE) is placed in protective metal
covers, which exclude direct contact of the
heating elements with water, respectively, no
scaling is formed on the heating elements,
which increases their service life and prolongs
their service life.

Control Panel

Temperature knob
OFF — the mark corresponds to the minimum
water temperature in the water heater
(heating off).
LOW — the mark corresponds to the minimum
water heating temperature in the
water heater (heating on).
ECO — the eco-mode mark corresponds
to the water heating temperature in
the water heater about 50-55 °С.
prevents the formation of scale;
increases the service life of the water
heater.
HIGH — the mark on the right corresponds
to the maximum heating water
temperature in the water heater
(75 °С).
Fig. 3.
Illustration of Control Panel
1. Power indicator lamp is on green light when
water heater is under normal energized
state. Heating indicator lamp is on red light
when water heater is under heating status.
2. Temperature control knob: adjusting water
temperature.
Operation:
Setting water heating temperature
Turn the temperature control knob can
adjust heating temperature. The temperature
adjusting range is 30~75°C. Rotate
clockwise to get higher temperature, rotate
counterclockwise to get lower temperature. It is
better to turn control knob to high temperature
area in order to get more hot water.
Heating and warming
Water heater can control temperature
automatically. When heating to setup
temperature water heater will cut off power
supply and stop heating. When water
temperature decrease to certain value, water
heater will connect power supply and reheat.
Note: hot water is supplied under heating/
warming mode.
Stop heating
When the control knob locates at "off", power
supply would be cut off and water heater stop
heating.

Water heater installation

Make sure that the electric water heater is
installed using original parts provided by the
manufacturer, which can support the weight
of the water heater filled with water. Do not
mount the water heater on the bracket until
do not make sure that the attachment is
securely fastened. Otherwise, the electric
water heater could fall
The following table describes the labels in this
manual and the corresponding labels in this
manual.
When selecting locations for mounting bolt
holes, make sure that both sides of the bath-
room walls or other room up to the water
heater body there is a clearance of at least
0.2 m and at least 0.5 m on the pipe connec-
tion side to facilitate access for maintenance
when necessary.
If the water heater is supplied directly from
wells, wells or water towers, a coarse filter
for the cold water entering the water heater
must be used to operate the water heater. The
coarse filter can be purchased from specialty
stores. If the coarse filter is not installed, the
product warranty is not valid.
The electric water heater must be installed
7
ENGLISH