Replacing A Turn Signal Light Bulb; Troubleshooting - Yamaha C3 2008 Owner's Manual

Troubleshooting<IXE>
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
2
1
ZAUM00**
1. Turn signal light lens
2. Bulb
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU24204
2
ZAUM00**
1. Turn signal light lens
2. Bulb
2. Remove the burnt-out bulb by push-
ing it in and turning it counterclock-
wise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.

Troubleshooting

Although Yamaha scooters receive a
thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
1
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting charts rep-
resent quick and easy procedures for
checking these vital systems yourself.
However, should your scooter require any
repair, take it to a Yamaha dealer, whose
skilled technicians have the necessary
tools, experience, and know-how to ser-
vice the scooter properly.
Use only genuine Yamaha replacement
parts. Imitation parts may look like
Yamaha parts, but they are often infe-
[ECA11191]
rior, have a shorter service life and can
lead to expensive repair bills.
6-59 6-24
EAU1722A
EAU25881
1
2
3
4
5
6
7
8
9