Table of Contents
Advertisement
Chapter 2 Preparations
(2)
Removal procedure
Remove the server from the rack in the following procedure. This can be removed by one person but it is
recommended more than one person work on this together.
1. Make sure that the server is turned off and then disconnect the power cord or all interface cables from the
server.
2. Remove the front bezel.
3. Slowly pull the server out while pressing the
unlock buttons located on either side of the
front of the server.
4. Because there are stoppers, the server will
come to a stop halfway. Press and hold the
rail stoppers on the rails and pull the server
out of the rack.
5. Hold the server firmly and remove it from the rack.
Important
Always remove the server with two or more persons.
Important
Be careful not to get your fingers caught in the rails and levers.
•
Important
While more than one person is supporting the bottom part of the server,
slowly pull out the server.
•
Do not apply pressure on the server from top when it is being pulled out.
Doing so cause the server to drop, which is dangerous.
•
Be careful not to get your finger caught in rails.
Express5800/R120d-1E User's Guide
2. Installation and Connection
Press the button
to unlock
Rail stopper
133
Advertisement
Table of Contents
