Makita 2702X1 Instruction Manual page 20

Table insert
(Part No. 317061-6)
When cutting grooves 5/16% 3/8",7/16" or 1/2" use this
table insert instead of the standard table insert.
To install the dado head set, proceed as follows:
1. Turn the tool off and unplug it before installing.
2. Remove the blade guard with the spreader.
3. Install the dado head set with the teeth pointing down
at the front of the table.
4. Use the chart below to select the proper cutters to
obtain the various cutting widths.
Spindle
1/8" 1/16" Dado Dad{
Inner Ring Outside Inside Inside Outside Outer Washer Outer Hex Hex
:lange Cutter cutter cutter cutter flange flange nut nut
CUT
WIDTH
@
f'-\ f_,\
1/8"
• • • • •
1/4"
• • • • • • •
5/16"
• • • • • • • •
3/8" • • • • • • • •
7/16"
• • • • • • • •
1/2"
• •
• Ox2 • • •
CAUTION:
• For a 1/8" cut width, the outside cutter is assembled to
the spindle in the same manner as the saw blade.
• The outer flange or the dado outer flange must be
used for each cut width.
• The hex nut alone must not be used to secure the
dado on to the spindle.
20