Table of Contents
Advertisement
10. Re-install grate to main housing being careful to align bulb ends into outer sup-
port pockets in the base grate. (see Fig. 8)
11.
Using the previously removed 2 screws, re-screw grate panel to main housing. (see
Fig. 4)
12. If using base tray, slide back into place on bottom of unit.
13. Plug in to test replaced bulb functions properly.
NOTE: If device fails to light after bulb replacement, unplug device, and following the
instructions above ensure that the bulb was correctly installed, and re-assemble unit.
NOTE: Bulb contains mercury, dispose of properly.
To order replacement bulbs email: help@umbagroup.com
Fig. 8
or call 1-888-338-6798
GRATE
Page 7
Advertisement
Table of Contents
